Toyota Emergency Device

The device has two modes:
1. Emergency start
2. Key programming
Before beginning any of the procedures it is important to wake the car up.
This is done by pressing the start button a few times and turning the
headlights on and off.
Mode 1: Emergency start
The switches have to be as follows: 1.ON 2.OFF 3.ON 4.OFF 5.ON 6.OFF 7.ON 8.OFF
The device needs to be plugged in and you need to look at the LED. If it is flashing RED, you need to press the start
button with the transponder emulator.
If it is solid RED, you need to touch the start button with the transponder emulator.
Mode 2: Key programming
Switch 1 is ALWAYS ON. Then depending on the number of keys you want to program, slide the corresponding switch
to the ON position (for example for 3 keys, SWITCH 3 should be set to ON).
The device needs to be plugged in and you need to look at the LED. If it is flashing RED, you need to press the start
button with the transponder emulator.
If it is solid RED, you need to touch the start button with the transponder emulator.
If the LED is solid GREEN, you need to touch the new key that you want to program to the start button so that it can be
programmed to the car.
Usually the car makes a sound.